Frequenzlist startup always with 14.105mhz?
Hello,
I have completed a setup for 2m.
I edited the frequency list and only left the 2m and 70cm frequencies.
However, every time VarAC starts, the 20m frequency is displayed and not the first frequency in the frequency list.
Is it possible to change this somehow?
76 Views
I don't understand what you mean Thomas
If you set the "load last freq", then upon VarAC startup - it will always go to the last freq that appeared on drop down, whether it was changed manually or by CAT control.
Please check it again. if I did not understand what you mean - please share some screenshots/videos so I can understand the experience you are seeing
Thank you
Irad