Bug reports

Hi Guys

I've had HF VARA 4.7.2 installed for while for with VarAC_V6_4.15 no worries.

I've downloaded and installed "VarAC_V6_6.13" as I was eager to utilise the FLRig cat control and with all configured up it successfully controls the rig and reads the current rig state fine.

However the moment I performed a Beacon or Ping (first CQ) after the first TX the application crashes no error displayed and the rig is left in TX state which I cancels via FLRig UI.

I then proceeded to switch from FLRig to FT991A direct, and similar with FLRig the moment I perform a Beacon or Ping (first CQ) after the first TX the application crashes no error displayed and the rig is left in TX state which I then had to reset the rig.

I reinstalled, and went through the same flow flow (FLRig, then Direct) with Debug logging enabled and attached as zip.

My Setup Details:

Rig: FT-991A

Attempt Cat 1: Via FLRig (successfully working fine with WSJT-X, Log4OM, JS8Call, FLDigi etc etc)

Attempt Cat 2: Direct FT-991A via com3 using CAT for TX

Regards

Mark (VK4TMZ)