Hello Alessandro ! Happy to read about your problem (no decoding or no transmission) I have also the FT-991A new and try to set up Vara... and... having same problem as you had. It seems you have solved the problem. Can you tell / send me the settings you are using now ? Settings on the VaraAc and on the rig. Thank you so far 73 de Bernhard DF7ET

Hi everyone . I have deleted my further comments, because I fond one OM who had the same equipment and the same problems before .... and solution 😀 ! The settings on the rig and the Vara programm should fit together... so the problem is ( as always ) sitting in front of the pc 😁 73 de Bernhard DF7ET

Hey Gary Irad !!! Thanks for reply. I agree that it should not be using the shift. I suppose the signal should be in the center from the begining.... but it never did. The only way so far I can find is to set the IF-shift to +500. Sending also some screenshots to show my situation. FT-991A parameter settings 63 psk tone        1000 64 other disp (0) >1500 65 other shift (0) >1500 072 DATA port select > Data 073 Data out level (50) > 80 FT-991A  -  M-list AGC fast Shift +500Hz Width 500Hz DT gain 50 Still no decoding :-( I would be happy if you can find any wrong settings... 73 de Bernhard DF7ET

Thanks very much for your answer and sugestions. I am a very newbeginner on digital modes and appreciate all tips.😀 Have also a new rig FT-991A... so a lot to learn. I have adjusted as you wrote. But my best result was to set 991A parameter SHIFT to +500 and WITDTH to 500Hz . That moves the signal good into the red lines. I can see and hear signals well but it will decode and show text very seldom and only on the monitor. No beacons and no text on the main window :-( I guess I overlooked some necessary setting.... but what?? Sorry bothering you with this stupid problem. 73 for now Bernhard DF7ET

Thanks very much on your answer. As I am a very newstarter on digital modes I need to try a lot and it takes time. I am going to try your settings... and more.... 73 for now.