I've been on a radio hiatus for about a year. Using a new PC now and install VarAC fresh. VarAC changed my rig to LSB after a change back to slot 1. I've seen this happen once before in the past day, but don't recall what caused it.
My rig is a Yaesu FTDX10 and I use DATA-U as the mode. Don't see anything in setup that specifics the default mode in VarAC.
de Steve N6VL
Thanks for the replies! Eventually the problem didn't repeat again. Unsure of the cause or remedy. And I did get the latest the VarAC_cat_commands.ini file.
mi indicativo EA1DP
Hello, entering the device configuration on the left side you have ptt configuration and on the right side you have frequency configuration, select cat, in the middle of the window you have to set the mode
data-u - 7105000 and test tab, if you click on the test tab there is a test of the cat ptt connection and mode with the device, I use yaesu ftdx10, it is very easy to connect and configure data-u mode
The Mode and Filter defaults are all set in the VarAC_cat_commands.ini file.