I wanted to enable the option for antenna tuner on band change, in order to be able to use the automatic frequency schedule. My tuner needs to be tuned with low power, so for now I always must do a manual tune in order not to destroy it.
PowerSDR CAT commands are: Tune on = ZZTU1, Tune off = ZZTU0. There is no command to enable tuning with a single command.
If I enter use AntennaTuner=ZZTU1; then tuning runs forever. If I try ZZTU1,ZZTU0; nothing happens (commands are sent too fast)
Would it be possible, to enhance the cat config to add a "wait" flag inside the CAT configuration, for example like this - tune, wait 10s, then send the disable tune: