Would it be possible to add a secondary Logging option such as UDP to give the ability to connect to more then 1 logging application or to send ADIF information to multiple sources. Example- while Using Log4OM or N1MM/ or ACL I would like to also send a ADIF UDP stream to say 127.0.0.1 UDP port 2233 as well Thanks Rick

Could you add a toggle to disable automatic Beacon TX on a band change: Scenario: Using a low QRP with with a solid state amp: and a manual tuner I have to watch and make sure i disable the automatic TX of Beacons if I change bands, I have a few times changed bands and before I could retune a antenna with a manual tuner gone into TX mode and tripped the amp because of high SWR- If there was an option to disable a Beacon on a band change and then have to manual click to reset auto beacon every X minutes that would allow time to adjust things before the beacon went into the next round of TX if the beacon is close to the time mark to begin that cycle. Thank you for considering

Option to disable send beacon ( if engaged) on band changes Scenario: If using a amp with a QRP rig at times when switching bands if you previously had the send beacon engaged and time was getting close to send a beacon, it will send it on band change as well : This can be bad for those of us using amps and manual tuners as it doesn't stop the beacon from sending if the time was close ( before you get a chance to retune an amp and or antenna. Having an option to disable Beacons on band change would be a safety feature allowing users to retune equipment before sending a beacon.

This video shows how I managed to get VarAC using EESDR (for SunSDR Transceivers) to work with the EESDR V3 alpha software.

Add TCI (Transceiver Control Interface) for EESDR (Expert Electronics) SDR rigs TCI allows frequency control, RX/TX via either of the two available Receivers/Transmitters TCI is faster for obtaining Rig Data and PTT control for EESDR rigs Be nice if VaraHF supported the TCI audio paths as which I will suggest to Jose, TCI info- maksimus1210/TCI: Transceiver Control Interface (github.com)